Shenzhen dingshen Industrial Co., Ltd
Shenzhen dingshen Industrial Co., Ltd
Add to Cart
VHF Data Transfer Module 900Mhz 1 Watt Two Way RF Radio Peer To Peer
Description:
The XTend RF Module was engineered to provide customers with an easy-to-use RF solution that provides reliable delivery of critical data between remote devices. The module transfers a standard asynchronous serial data stream, operates within the ISM 900 MHz frequency band and sustains up to 115.2 Kbps data throughput.
Key Features:
Advance Networking & Security
True Peer-to-Peer (no Master device required),Point-to-Point, Point-to-Multipoint & Multidrop
FHSS (Frequency hopping spread spectrum).10hopping channels,each with over 65,000 unique network addresses available
AES Encryption:
performed using a FIPS197 certified implementation on a Phillips LPC microcontroller
128-bit AES for international variant.
Low power consumption:
2.8 - 5.5 V Supply Voltage.
Pin,serial port and Cyclic
Software sleep modes supported
Shutdown pin enables hardware sleep mode,that draws only 5 µA(typical)
Specifications:
| Performance | ||
| Transmit power output (software selectable using PL command) | @9600bpsthroughput data rate 1mW-1Watt | @115200bps throughput data rate 1mW-1Watt |
|
Throughput Data Rate (software selectable using BR command) | 9,600bps | 115,200bps |
| Receiver sensitivity | 10,000bps -110dBm | 115,200bps -100dBm |
| Power requirement | ||
| Receive current | 80mA | |
| Shutdown mode power down |
5 µA typical | |
| Pin Sleep Power Down | 147 µA | |
| Networking&security | ||
| Frequency | 902-928 MHz, 915-928 MHz International variant | |
| Spread spectrum | FHSS (Frequency Hopping Spread Spectrum) | 456 |
| Modulation | FSK (Frequency Shift Keying) | |
| Supported Network Topologies Channel Capacity | Peer-to-Peer (“Master/Slave” relationship not required), Point-to-Point, Point-to-Multipoint, Mesh 10 hop sequences share 50 frequencies | |
| Encryption | 256-bit or 128-bit AES Encryption - Refer to the KY Command [p29] to implement | |
| Physical Properties | ||
| RF module board size | 1.44” x 2.38” x 0.20” (3.65 cm x 6.05 cm x 0.51 cm) | |
| Weight | 0.64 oz. (18 g) | |
| Connector | 9-pin | |
| Operating Temperature | -40 to 85º C (industrial) | |
| Antenna | ||
| Connector Options | RPSMA (Reverse-polarity SMA) or MMCX | |
| Impedance | 50 ohms unbalanced |
Package:
1* Module
1* RS-232data cable
1* power line
1* small antenna
Optional accessories:
RS-232 programming cable. (For user get through the computer's RS232 interface module parameter settings)
USB interface programming join line. (for user get through the computer's USB interface module parameter settings)
the data transmission test equipment. (User-friendly in the selection or the actual use of the module testing)
optional antenna. (The user can follow according to their actual situation to choose their own antenna,so that achieve the best results)
Remark:
1, in order to achieve the best communication results, try to use a smaller power supply ripple factor, the maximum current power supply module should be greater than 1.5 times of the maximum current.
2, TTL, RS-485, RS-232 three interfaces can only choose one.
3, the transfer rates are divided into: the number of interfaces rate: users can be changed by KYLPRO.exe PC software;